Back to

W O R K S H O P

page

Here we explain how you fit our motors in to you Unimat 3 or Unimat SL machines.

U n i m a t  3

unim 3 motor fit.jpg

In accordance to Emco design, original Emco Unimat 3 motors were fitted by two M5 x 12 screws (no.8 on the attached drawing), with two 12mm OD/5.2mm ID conical spring washers (no. 9 on the attached drawing), and two spacers (no.1 on the attached drawing).

Please, be advise that:

You CAN use the same original Emco screws, washers and spacers to fit your new PJTOOLMAKERS motor in to your Unimat 3 machine.

You DO NOT need any additional fittings to fit your new PJTOOLMAKERS motor in to your Unimat 3 machine.

You will however DO need different belts' circumferential lengths. To find out how you can easily make your own Unimat drive belts check here:

U n i m a t  SL

unimat%20sl%20motor%20fitting_edited.jpg

In accordance to Emco design, original Emco Unimat SL motors were fitted by two M5 x 12 screws.

Please, be advise that:

You CAN use the same original Emco screws to fit your new PJTOOLMAKERS motor in to your Unimat SL machine.

You DO NOT need any additional fittings to fit your new PJTOOLMAKERS motor in to your Unimat SL machine.

You will however DO need different belts' circumferential lengths. To find out how you can easily make your own Unimat drive belts check here: